Remote Keyless Entry (RKE) System Operation

The Remote Keyless Entry (RKE) transmitter functions work up to 60 m (195 feet) away from the vehicle.

There are other conditions which can affect the performance of the transmitter. See Remote Keyless Entry (RKE) System.

With Remote Start
With Remote Start Shown, Without Remote Start Similar

vehicles with this (Remote Vehicle Start): For vehicles with this feature, press to start the engine from outside the vehicle using the RKE transmitter. See Remote Vehicle Start for additional information.

doors. If enabled through (Lock): Press to lock all the doors. If enabled through the Driver Information Center (DIC), the parking lamps flash once to indicate locking has occurred. If enabled through the DIC, the horn chirps when within five seconds. See DIC Vehicle Customization for additional information. is pressed again within five seconds. See DIC Vehicle Customization for additional information.

Pressing theft-deterrent system. may arm the content theft-deterrent system.

See Content Theft-Deterrent.

driver door. If  is (Unlock): Press once to unlock the driver door. If pressed again within five seconds, all remaining doors is pressed again within five seconds, all remaining doors unlock. The interior lamps come on and stay on for 20 seconds or until the ignition is turned on. If enabled through the DIC, the parking lamps flash twice to indicate unlocking has occurred. See DIC Vehicle Customization .

Pressing disarms the content on the RKE transmitter disarms the content theft-deterrent system. See Content Theft-Deterrent.

hold for (Remote Trunk Release): Press and hold for about one second to unlock the trunk. The transmission must be in P (Park).

Press and release (Vehicle Locator/Panic Alarm): Press and release to locate the vehicle. The turn signal lamps flash and the horn sounds three times.

Press and hold two seconds to for more than two seconds to activate the panic alarm. The turn signal lamps flash and the horn sounds repeatedly for 30 seconds.

The alarm turns off when the ignition is moved to ON/RUN or ignition must is pressed again. The ignition must be in LOCK/OFF for the panic alarm to work.

See also:

Programming Transmitters to the Vehicle
Only RKE transmitters programmed to the vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer. The vehicle can be reprogrammed so ...

Seat Position
Seat Position WARNING! You can lose control of the vehicle if you try to adjust a manual driver seat while the vehicle is moving. The sudden movement could startle and confuse you, or ma ...

Finish Care
Occasional waxing or mild polishing of the vehicle by hand may be necessary to remove residue from the paint finish. Approved cleaning products can be obtained from your dealer. If the vehicle has a ...