Programming Transmitters to the Vehicle

Only RKE transmitters programmed to the vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer/retailer. When the replacement transmitter is programmed to the vehicle, all remaining transmitters must also be programmed. Any lost or stolen transmitters no longer work once the new transmitter is programmed.

Each vehicle can have up to eight transmitters programmed to it. See “Remote Key” under DIC Operation and Displays.

    See also:

    Instrument Panel Fuse Block
    The instrument panel fuse block is on the driver side of the instrument panel. To access the fuses: 1. Access the fuse block by opening the storage compartment. 2. Pull straight down and out to ...

    Tire Sealant and Compressor Kit
    WARNING: Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine exhaust may enter the vehicle. Engine exhaust contains Carbon Monoxide (CO) which cannot be seen or smel ...

    SBZA Detection Zones
    The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, or 3.5m(11 ft). This zone starts at each side mirror and goes back approximately 5.0 m(16 ft). Th ...