Vehicle Messages
Messages displayed on the DIC indicate the status of the vehicle or some action that may be needed to correct a condition. Multiple messages may display one after the other.
The messages that do not require immediate action can be acknowledged and cleared by pressing SET/CLR. The messages that require immediate action cannot be cleared until that action is performed. All messages should be taken seriously and clearing the messages does not correct the problem.
See also:
Ending Cruise Control
There are three ways to end cruise control:
• Step lightly on the brake pedal.
• Press the button on the steering
wheel.
• Press the button on the steering
wheel. ...
Headlamps, Front Turn Signal, andParking Lamps
To replace a bulb, do the following:
1. Open the hood.
2. Remove the grille by grasping and pulling it
forward.
3. Lift the two headlamp retaining clips.
4. Pull the headlamp assembly away from ...
Jump Starting (On-board with eAssist Only)
If the vehicle fails to crank, it may
be jump started by using the eAssist
battery to charge the 12-volt battery.
Use the following procedure to
activate the on-board jump start
using the DIC ...