Deleting a Paired Phone

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Bluetooth”. The system responds with “Bluetooth ready” followed by a tone.

3. Say “Delete”. The system asks which phone to delete followed by a tone.

4. Say the name of the phone to be deleted. If the phone name is unknown, use the “List” command for a list of all paired phones. The system responds with “Would you like to delete <phone name>? Yes or No” followed by a tone.

5. Say “Yes” to delete the phone. The system responds with “OK, deleting <phone name>”.

    See also:

    Rear Seat Pass-Through Door
    The vehicle may have a door in the rear seat that provides access to the trunk. Lower the rear seat armrest to access the pass-through door. Pull the release handle to open the door. To close, pus ...

    Bulb Replacement
    For the proper type of replacement bulbs, see Replacement Bulbs. For any bulb changing procedure not listed in this section, contact your dealer. ...

    Radio Messages
    CAL ERR (Calibration Error): The audio system has been calibrated for your vehicle from the factory. If CAL ERR displays it means that the radio has not been configured properly for your vehicle a ...