Compass Calibration Procedure

1. Before calibrating the compass, check that the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window, sunroof, climate controls, seats, etc. during the calibration procedure.

2. Press the vehicle information button until PRESS TO CALIBRATE COMPASS displays. TO CALIBRATE COMPASS displays.

3. Press the set/reset button to start the compass calibration.

4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 5 mph (8 km/h) to complete the calibration.

The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete.

The DIC display will then return to PRESS CALIBRATE COMPASS. TO CALIBRATE COMPASS.

    See also:

    Liftgate Release
    To unlock the liftgate, use the power door lock switch or the remote keyless entry transmitter. The liftglass will also unlock when the liftgate is unlocked. Press the button on the liftglass to op ...

    Braking
    Braking action involves perception time and reaction time. Deciding to push the brake pedal is perception time. Actually doing it is reaction time. Average driver reaction time is about thr ...

    Radio Reception
    Frequency interference and static can occur during normal radio reception if items such as cellular phone chargers, vehicle convenience accessories, and external electronic devices are plu ...