Increasing Speed While UsingCruise Control

There are two ways to go to a higher speed:

• Use the accelerator pedal to get to the higher speed. Press the button at the end of the lever, then release the button and the accelerator pedal. You will now cruise at the higher speed.
• Move the cruise switch from on to resume/ accelerate. Hold it there until you get up to the desired speed and then release the switch.

To increase your speed in very small amounts, move the switch briefly to resume/accelerate.

Each time you do this, your vehicle will go about 1 mph (1.6 km/h) faster.

    See also:

    Turning the Rear Vision Camera System On or Off
    To turn the RVC system on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. 5. Select Camera. ...

    When the System Does Not Seem to Work Properly
    If the URPA system will not activate due to a temporary condition, the message PARK ASSIST OFF will be displayed on the DIC and a red light will be shown on the rear URPA display when the shift ...

    Shifting Into Park
    WARNING! It can be dangerous to get out of the vehicle if the shift lever is not fully in P (Park) with the parking brake firmly set. The vehicle can roll. If you have left the engine runni ...