Starting the Vehicle

1. Aim the RKE transmitter at the vehicle. 2. Press and release 2, press and hold  until the turn signal. 3. Immediately after completing Step 2, press and hold lamps flash, or for about two seconds if the vehicle is not in view. until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Compass Calibration
    Press and hold the on/off button to activate the compass calibration mode. CAL will be displayed in the compass window on the mirror. The compass can be calibrated by driving the vehicle in circ ...

    Uniform Tire Quality Grading
    Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: ...

    Turn Signals When Towing a Trailer
    The arrows on your instrument panel will flash whenever you signal a turn or lane change. Properly hooked up, the trailer lamps will also flash, telling other drivers you’re about to turn, cha ...