Initial Drive Information

See also:

Starting the Vehicle
1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold until the turn signal lamps flash, or for about two seconds if the vehicl ...

Using the Digit Dial Command
1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...

Cleaning Exterior Lamps/Lenses and Emblems
Use only lukewarm or cold water, a soft cloth, and a car washing soap to clean exterior lamps and lenses. Follow instructions under "Washing the Vehicle" later in this section. ...