See also:

Checking the Restraint Systems
Safety Belts Now and then, check that the safety belt reminder light, safety belts, buckles, latch plates, retractors, and anchorages are all working properly. Look for any other loose or damage ...

Starting the Vehicle
1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold until the turn signal lamps flash, or for about two seconds if the vehicl ...

Compass Calibration Procedure
1. Before calibrating the compass, check that the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section. ...