Timer
This display can be used as a timer.
To start the timer, press SET/CLR while Timer is displayed. The display will show the amount of time that has passed since the timer was last reset, not including time the ignition is off. Time will continue to be counted as long as the ignition is on, even if another display is being shown on the DIC. The timer will record up to 99 hours, 59 minutes, and 59 seconds (99:59:59) after which the display will return to zero.
To stop the timer, press SET/CLR briefly while Timer is displayed. To reset the timer to zero, press and hold SET/CLR.
See also:
Trunk Release
To open the trunk, press . ...
Taillamps and Back-Up Lamps
A. Taillamp
B. Back-up Lamp
To replace an auxiliary taillamp or back-up lamp bulb:
1. Open the trunk. See Trunk.
2. Remove the three fasteners from the trunk trim.
3. Pull back the trunk trim ...
Emergency Trunk Release Handle
Notice:
Do not use the emergency trunk release handle as a tie-down or anchor point when
securing items in the trunk as it could damage the handle. The emergency trunk release
handle is only i ...
