Starting the Vehicle

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing.

3. Immediately after completing Step 2, press and hold the turn signal lamps flash, or for until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Regenerative Braking
    Regenerative braking takes some of the energy from the moving vehicle and turns it into electrical energy. This energy is then stored in the vehicle's high voltage battery system, contributin ...

    Engine Compartment Fuse Block
    To remove the fuse block cover, press the three retaining clips on the cover and lift it straight up. Notice: Spilling liquid on any electrical component on the vehicle may damage it. Always keep t ...

    Tire Pressure Monitor System
    The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. TPMS sensors are mounted on each tire and wheel assembly, except the spare tire. The TPMS ...