Sending a Stored Name Tag During a Call

1. Press with “Ready”. The system responds with “Ready” followed by a tone.

2. Say “Send name tag.” The system responds with “Say a name tag to send tones” followed by a tone.

3. Say the name tag to send.

• If the system clearly recognizes the name tag it responds with “OK, Sending <name tag>” and the dial tones are sent and the call continues.

• If the system is not sure it recognized the name tag properly, it responds “Dial <name tag>, Please say yes or no?” followed by a tone. If the name tag is correct, say “Yes”. The system responds with “OK, Sending <name tag>” and the dial tones are sent and the call continues.

    See also:

    Programming with a Recognized Transmitter (Keyless Access Vehicles Only)
    A new transmitter can be programmed to the vehicle when there is one recognized transmitter. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, mus ...

    Drunk Driving
    Death and injury associated with drinking and driving is a global tragedy. WARNING Drinking and then driving is very dangerous. Your reflexes, perceptions, attentiveness, and judgment can be aff ...

    Additional Required Services At Each Fuel Stop
    • Engine oil level check. See Engine Oil. • Engine coolant level check. See Engine Coolant (4.6L Engine) or Engine Coolant (3.9L Engine). • Windshield washer fluid level check. See Windshi ...