To Transfer Audio to the In-Vehicle Bluetooth System
The cellular phone must be paired and connected with the Bluetooth system before a call can be transferred.
The connection process can take up to two minutes after the key is turned to the ON/RUN or ACC/ACCESSORY position.
During a call with the audio on the cell phone, press
for more than two seconds. The audio switches from the
cell phone to the vehicle.
See also:
Stoplamp,Taillamp, and Turn Signal Lamp
Driver Side Shown, Passenger Side Similar
A. Taillamp
B. Turn Signal Lamp
C. Stoplamp/Taillamp
To replace any one of these bulbs:
1. Open the trunk.
2. Remove the push pins securing the trunk ...
Radio Messages
CAL ERR (Calibration Error): The audio system
has been calibrated for your vehicle from the
factory. If CAL ERR displays, it means that the
radio has not been configured properly for
the vehicle a ...
Shifting Into Park
WARNING!
It can be dangerous to get out of
the vehicle if the shift lever is not
fully in P (Park) with the parking
brake firmly set. The vehicle can
roll. If you have left the engine
runni ...