Call Waiting

Call waiting must be supported on the Bluetooth phone and enabled by the wireless service carrier to work.

• Press when to answer an incoming call when another call is active. The original call is placed on hold.

• Press original call. again to return to the original call.

• To ignore the incoming call, continue with the original call with no action.

• Press call and to disconnect the current call and switch to the call on hold.

    See also:

    Using the Directory Command
    The directory command lists all of the name tags stored by the system. To use the directory command: 1. Press and hold for two seconds. The system responds with “Ready” followed by a tone. ...

    Programmable Locking Feature
    Following are the two locking modes that can be programmed: Mode 1: All doors lock when the transmission is shifted out of PARK (P). Mode 2: All doors lock when the vehicle speed is greater t ...

    Battery Run-Down Protection
    This feature helps prevent the battery from being drained, if the interior courtesy lamps, reading/map lamps, visor vanity lamps or trunk lamp are accidentally left on. If any of these lamps are ...