Programming Universal HomeRemote — Rolling Code
Rolling code garage door openers are used for garage doors produced after 1996 and are code protected. Rolling code means the coded signal is changed every time your remote control garage door opener is used.
Programming a rolling code garage door opener involves time-sensitive actions, so read the entire procedure before you begin. If you do not follow these actions, the device will time out and you will have to repeat the procedure.
Follow these steps to program up to three channels:
1. Press the two outside buttons at the same time for one to two seconds, and immediately release them.
2. Go to the garage. Locate the garage door motor head and press and release the “learn” button.
After pressing the “learn” button, you have 10 to 30 seconds to complete Step 4 depending on your garage control unit. If you cannot locate the “learn” button, refer to the owners guide for your garage door opener.
3. Press and hold the button you would like
to use to control the garage door until the
garage door moves. The indicator light,
above the selected button, should slowly
blink. You may need to hold the button from
five to 20 seconds.
4. Immediately release the button when the
garage door moves. The indicator light will
blink rapidly until programming is complete.
5. Press and release the button again. The
garage door should move, confirming that
programming is successful and complete.
To program another device such as an additional garage door opener, a security device, or home lighting, repeat Steps 1 through 6, choosing a different function button in Step 4 than what you used for the garage door opener.
See also:
Servicing the Airbag-Equipped Vehicle
Airbags affect how the vehicle
should be serviced. There are parts
of the airbag system in several
places around the vehicle. Your
dealer and the service manual have
information about servic ...
Heated Mirrors
The vehicle may have heated mirrors:
(Rear Window Defogger): Press to
heat the mirrors.
See “Rear Window Defogger” under Climate Control Systems for more information. ...
Instrument Panel Overview
A. Air Vents .
B. Headlamp High/Low-Beam Changer.
Turn and Lane-Change Lever. See Turn and Lane-Change Signals . Driver Information
Center (DIC) Buttons. See Driver Information Center (DIC) .
...