Single CD (MP3) Player
To set the time and date:
1. Turn the ignition key to ACC/ACCESSORY or
ON/RUN. Press
to turn the radio
on.
2. Press
and the HR, MIN, MM, DD,
YYYY (hour,
minute, month, day, and year) displays.
3. Press the softkey located below any one of the tabs that you want to change.
4. To increase the time or date, do one of the following:
• Press the softkey located below the selected tab.
• Press
SEEK, or
FWD.
• Turn
clockwise.
5. To decrease the time or date, do one of the following:
• Press
SEEK or
REV.
• Turn
counterclockwise.
The date does not automatically display. To see the
date press
while the radio is on.
The date with display
times out after a few seconds and goes back to the
normal radio and time display.
To change the time default setting from 12 hour to 24 hour or to change the date default setting from month/day/year to day/month/year:
1. Press
and then the softkey
located below the
forward arrow label. Once the time 12H and 24H,
and the date MM/DD/YYYY (month, day, and
year) and DD/MM/YYYY (day, month, and year)
displays.
2. Press the softkey located below the desired option.
3. Press
again to apply the
selected default, or
let the screen time out.
See also:
Heated Seats
On vehicles with heated seats, the controls are located
on the front doors and the ignition must be on to
use the feature.
: Press to heat the seat and
seatback.
: Press to heat the seatback ...
Window Messages
OPEN, THEN CLOSE DRIVER WINDOW
This message is displayed when the window needs to be reprogrammed. If the vehicle's
battery has been recharged or disconnected, you will need to reprogram each f ...
Erasing Universal Home RemoteButtons
To erase programming from the three Universal
Home Remote buttons do the following:
1. Press and hold down the two outside buttons
until the indicator light begins to flash, after
20 seconds. Do ...
