Setting Cruise Control

Cruise control will not work if the parking brake is set, or if the master cylinder brake fluid level is low.

The cruise control light on the instrument panel cluster comes on after the cruise control has been set to the desired speed. See Instrument Panel Cluster.

WARNING:
If you leave your cruise control on when you are not using cruise, you might hit a button and go into cruise when you do not want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control.

1. Press the 2. Get up to the desired speed. button.

2. Get up to the desired speed.

3. Press and release the SET– button located on the steering wheel.

4. Take your foot off the accelerator.

    See also:

    Memory Seat, Mirrors, and Pedals
    The controls for the memory function are located on the driver’s door. These buttons are used to program and recall memory settings for the driver’s seating position, both outside mirror ...

    To Use the Engine Coolant Heater
    1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. 3.6L V6 Engine The electrical cord is located on the driver side of the engine compartment, between the fender and ...

    Finding a Station
    BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection. TUNE: Turn this knob to select radio stations. SEEK : Press either the S ...