When the System Does Not Seem to Work Properly

If the URPA system will not activate due to a temporary condition, the message PARK ASSIST OFF will be displayed on the DIC and a red light will be shown on the rear URPA display when the shift lever is moved into R (Reverse). This occurs under the following conditions:

• The driver disables the system.

• The ultrasonic sensors are not clean. Keep the vehicle’s rear bumper free of mud, dirt, snow, ice and slush. For cleaning instructions, see Washing Your Vehicle.

• A trailer was attached to the vehicle, or a bicycle or an object was hanging out of the trunk during the last drive cycle, the red light may illuminate in the rear display. Once the attached object is removed, URPA will return to normal operation.

• A tow bar is attached to the vehicle.

• The vehicle’s bumper is damaged. Take the vehicle to your dealer/retailer to repair the system.

• Other conditions may affect system performance, such as vibrations from a jackhammer or the compression of air brakes on a very large truck.

If the system is still disabled after driving forward at least 25 km/h (15 mph), take the vehicle to your dealer/retailer.

    See also:

    Limited-Slip Differential
    Vehicles with a limited-slip differential can give more traction on snow, mud, ice, sand, or gravel. It works like a standard differential most of the time, but when traction is low, this fea ...

    Reprogramming a Single Universal Remote System Button
    To reprogram any of the three Universal Remote system buttons: 1. Press and hold the desired Universal Remote system button. Do not release the button. 2. The indicator light will begin to ...

    Listing Stored Numbers
    The list command will list all the stored numbers and name tags. Using the “List” Command 1. Press . The system responds “Ready,” followed by a tone. 2. Say “Directory.” 3. Say “Ha ...