High-Beam Headlamp/ Low-Beam Headlamp
1. Open the hood. See Hood .
2. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.
3. Remove the battery cover by pulling it straight up.
4. Remove the headlamp bulb access cover.
5. Turn the bulb counterclockwise and pull straight back.
6. Disconnect the wiring harness connector from the bulb.
7. Install the new bulb in the headlamp assembly by turning clockwise.
8. Reconnect the wiring harness connector.
9. Install the headlamp bulb access cover.
10. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer.
11. Reinstall the battery cover.
See also:
Shifting Into Park (P)
CAUTION:
It can be dangerous to get out of your
vehicle if the shift lever is not fully in
PARK (P) with the parking brake firmly set.
Your vehicle can roll. If you have left the
engine runni ...
How to Inspect the Engine Air Cleaner/Filter
To inspect the air cleaner/filter, remove the filter from the vehicle and lightly
shake the filter to release loose dust and dirt. If the filter remains covered with
dirt, a new filter is required ...
StabiliTrak® OFF Light
This light comes on when the StabiliTraK system is turned off.
If the Traction Control System (TCS) is off, wheel spin is not limited.
If StabiliTrak is off, the system does not assist in controll ...