Safety Belt Care
Keep belts clean and dry.
WARNING
Do not bleach or dye safety belts. It may severely weaken them. In a crash, they might not be able to provide adequate protection. Clean safety belts only with mild soap and lukewarm water.
See also:
Ignition Positions (Key Access)
Ignition Positions (Key Access)
The ignition switch has four different
positions.
Notice:
Using a tool to force the
key to turn in the ignition could
cause damage to the switch or
break t ...
Reducing Speed While UsingCruise Control
Press in the set button at the end of the lever until
you reach the desired speed, then release it.
Each time you do this, you will go about
1 mph (1.6 km/h) slower. ...
Rear Axle
When to Check Lubricant
It is not necessary to regularly check rear axle
fluid unless you suspect there is a leak or you hear
an unusual noise. A fluid loss could indicate a
problem. Have it inspe ...
