Storing the Tire Sealant and Compressor Kit
To access the tire sealant and compressor kit:
1. Open the trunk. See Trunk.
2. Lift the cover.

With Pressure Relief Button

With Pressure Deflation Button
3. Turn the wing nut counterclockwise to remove it.
4. Remove the tire sealant and compressor kit.
To store the tire sealant and compressor kit, reverse the steps.
See also:
Jump Starting (On-board with eAssist Only)
If the vehicle fails to crank, it may
be jump started by using the eAssist
battery to charge the 12-volt battery.
Use the following procedure to
activate the on-board jump start
using the DIC ...
Programming Transmitters to the Vehicle
Only RKE transmitters programmed to the vehicle will work. If a transmitter is
lost or stolen, a replacement can be purchased and programmed through your dealer.
The vehicle can be reprogrammed so ...
Backglass Antenna
The AM-FM antenna is integrated
with the rear window defogger,
located in the rear window. Make
sure that the inside surface of the
rear window is not scratched and
that the lines on the gla ...
