Leaving After Parking on a Hill

1. Apply and hold the brake pedal while you:

1.1. Start the engine.

1.2. Shift into a gear.

1.3. Release the parking brake.

2. Let up on the brake pedal.

3. Drive slowly until the trailer is clear of the chocks.

4. Stop and have someone pick up and store the chocks.

    See also:

    Your Responsibility
    Increase the volume of the radio if the OnStar advisor cannot be heard. If the light next to the OnStar buttons is red, the system may not be functioning properly. Press and request a vehicle ...

    Reading Lamps
    There are front and rear reading lamps. The front reading lamps are located in the overhead console. Press to turn each lamp on or off. The rear reading lamps are located in the headliner. ...

    Jump Starting (On-board with eAssist Only)
    If the vehicle fails to crank, it may be jump started by using the eAssist battery to charge the 12-volt battery. Use the following procedure to activate the on-board jump start using the DIC ...