Automatic Operation
The system automatically controls the fan speed, air delivery, air conditioning, and recirculation in order to heat or cool the vehicle to the desired temperature.
When the AUTO indicator light is on, the system is in full automatic operation. If the air delivery mode, fan speed, recirculation, or air conditioning setting is adjusted, the AUTO indicator turns off and the selected settings will appear on the display.
To place the system in automatic mode do the following:
1. Press AUTO.
2. Set the temperature. Allow the system time to stabilize. Adjust the temperature as needed for best comfort.
To improve fuel efficiency and to cool the vehicle faster, recirculation may be automatically selected in warm weather. The recirculation light will not come on. Press > to select recirculation; press it again to select outside air.
TEMP
(Temperature
Control): Press to increase or
decrease the temperature.
See also:
Lumbar Adjustment
Lumbar Adjustment
To adjust the lumbar support,
if available:
• Press and hold the front or rear
of the control to increase or
decrease lumbar support.
• Press and hold the top or botto ...
Your Responsibility
Increase the volume of the radio if the OnStar advisor
cannot be heard.
If the light next to the OnStar buttons is red, the system
may not be functioning properly. Press
and request
a vehicle ...
Trunk Deck Inboard Taillamp and Backup Lamp
Driver Side Shown, Passenger Side Similar
A. Backup Lamp
B. Taillamp
To replace any one of these bulbs:
1. Open the trunk.
2. Remove the push pins (A) retaining the trunk deck trim cover.
3. ...