Flash-to-Pass
To flash the high beams, pull the turn signal/lane change lever toward you, and release.
See also:
If the Light Is On Steady
You may be able to correct the emission system
malfunction by considering the following:
Did you recently put fuel into your vehicle?
If so, reinstall the fuel cap, making sure to fully
install ...
Bulb Replacement
For the proper type of replacement bulbs, see Replacement Bulbs .
For any bulb-changing procedure not listed in this section, contact your dealer. ...
Increasing Speed While UsingCruise Control
There are two ways to go to a higher speed:
• Use the accelerator pedal to get to the higher
speed. Press the button at the end of the
lever, then release the button and the
accelerator pedal. ...
