Using the Digit Store Command

The digit store command allows a phone number to be stored by entering the digits individually.

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Digit Store”. The system responds with “Please say the first digit to store” followed by a tone.

3. Say the first digit to be stored. The system will repeat back the digit it heard followed by a tone.

Continue entering digits until the number to be stored is complete.

• If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.

• To hear all of the numbers recognized by the system, say “Verify” at any time and the system will repeat them.

4. After the complete number has been entered, say “Store”. The system responds with “Please say the name tag” followed by a tone.

5. Say a name tag for the phone number. The name tag is recorded and the system responds with “About to store <name tag>. Does that sound OK?”.

• If the name tag does not sound correct, say “No” and repeat Step 5.

• If the name tag sounds correct, say “Yes” and the name tag is stored. After the number is stored the system returns to the main menu.

    See also:

    Control of a Vehicle
    You have three systems that make your vehicle go where you want it to go. They are the brakes, the steering, and the accelerator. All three systems have to do their work at the places where the ...

    Your Responsibility
    Increase the volume of the radio if the OnStar Advisor cannot be heard. If the light next to the OnStar buttons is red, the system may not be functioning properly. Push and request a vehicle diagnos ...

    Connections
    OnStar Hands-Free Calling allows calls to be made and received from the vehicle. The vehicle can also be controlled from a cell phone through the OnStar mobile app. See www.onstar.com for coverage ...