Flash-to-Pass
This feature lets you use the high-beam headlamps to signal the driver in front of you that you want to pass. It works even if your headlamps are off.
Pull the turn signal lever toward you briefly to flash-to-pass.
If the headlamps are off or on low beam, the high-beam headlamps will turn on. They will stay on as long as you hold the lever toward you and the high-beam indicator on the instrument panel cluster will come on.
See also:
Using the Delete All Name Tags Command
The delete all name tags command deletes all stored
phone book name tags and route name tags for OnStar
(if present).
To use the delete all name tags command:
1. Press and hold for two seconds. ...
Every Engine Oil Change
► Change engine oil and filter.
Reset oil life system. See Engine Oil and Engine Oil Life System . An Emission Control Service.
► Engine coolant level check. See Engine Coolant .
...
Hazard Warning Flashers
Hazard Warning Flasher: Press this button located on the instrument panel above the audio system, to make the front and rear turn signal lamps flash on and off.
Press again to turn the flashe ...