Lap Belt
This part is only for the lap belt. To learn how to wear a lap-shoulder belt, see Lap-Shoulder Belt.
You vehicle may have a center seating position.
When you sit in the center front seating position, you have a lap safety belt, which has no retractor.
To make the belt longer, tilt the latch plate and pull it along the belt.
Buckle, position and release it the same way as the lap part of a lap-shoulder belt.
To make the belt shorter, pull its free end as shown until the belt is snug.
If the belt is not long enough, see Safety Belt Extender .
Make sure the release button on the buckle is positioned so you would be able to unbuckle the safety belt quickly if necessary.
If you find that the latch plate will not go fully into the buckle, see if you are using the correct buckle. Be sure that the latch plate clicks when inserted into the buckle.
See also:
Engine Heater
The engine heater, if available, can help in cold weather conditions at or below
−18°C (0°F) for easier starting and better fuel economy during engine warm-up. Plug
in the heater at least ...
How to Add Coolant to the
Recovery Tank
WARNING:
You can be burned if you spill coolant on hot
engine parts. Coolant contains ethylene glycol and
it will burn if the engine parts are hot enough. Do
not spill coolant on a hot engine.
...
Tires
Use a stiff brush with tire cleaner to clean the tires.
Notice: Using petroleum-based tire dressing products on the vehicle may damage
the paint finish and/or tires. When applying a tire dressing, ...