Reprogramming a Single UniversalHome Remote Button
To program a device to Universal Home Remote using a Universal Home Remote button previously trained, follow these steps:
1. Press and hold the desired Universal Home
Remote button. Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the Universal
Home Remote button, proceed with Step 2
under “Programming Universal Home Remote”
shown earlier in this section.
See also:
Jump Starting
If your vehicle’s battery has run down, you may
want to use another vehicle and some jumper
cables to start your vehicle. Be sure to use
the following steps to do it safely.
CAUTION:
Batterie ...
Rear Window Lockout
This feature prevents the rear passenger windows from operating, except from
the driver position. The rear door locks will also be disabled and only operate
from the driver door. This feature on ...
Driving in Rain and on Wet Roads
Rain and wet roads can reduce vehicle traction
and affect your ability to stop and accelerate. Always
drive slower in these types of driving conditions
and avoid driving through large puddles an ...
