Hood
To open the hood:
1. Pull up on the hood release handle. It is located inside the vehicle to the left of the steering column.
2. Go to the front of the vehicle and with hand palm side down, slide the secondary hood release handle toward the driver side of the vehicle.
3. Lift the hood and pull the prop rod by the sleeve from the retainer, located above the radiator.
4. Securely place the hood prop into the slot on the underside of the hood.
To close the hood:
1. Before closing the hood, be sure all the filler caps are on properly. Then, lift the hood to relieve pressure on the hood prop. Remove the hood prop from the slot on the underside of the hood and return the prop to its retainer. The prop rod must click into place when returning it to the retainer to prevent hood damage.
2. Lower the hood 20 cm (8 in) above the vehicle and release it so it fully latches. Check to make sure the hood is closed and repeat the process if necessary.
See also:
Canceling a Remote Start
To cancel a remote start, do one of the following:
. Aim the RKE transmitter at the vehicle and press and hold
until the parking lamps turn off.
. Turn on the hazard warning flashers.
. Turn t ...
DIC Vehicle Customization
Your vehicle may have customization capabilities
that allow you to program some features to
one setting based on your preference. All of the
customizable options listed may not be available
on you ...
Gate Operator and CanadianProgramming
Canadian radio-frequency laws require transmitter
signals to time out or quit after several seconds
of transmission. This may not be long enough
for Universal Home Remote to pick up the signal
dur ...