Starting the Vehicle

To start the engine using the remote start feature:

1. Aim the RKE transmitter at the vehicle.
2. Press and release 3. Immediately after completing Step 2, press and hold.
3. Immediately after completing Step 2, press and hold or for about two seconds if the vehicle is not in view. until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Start the vehicle before driving.

    See also:

    Customer Satisfaction Procedure
    Your satisfaction and goodwill are important to your dealer and to Buick. Normally, any concerns with the sales transaction or the operation of the vehicle will be resolved by your dealer's sa ...

    Using the Re-dial Command
    1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...

    Lumbar Adjustment
    Lumbar Adjustment If available, press and hold the front or rear of the control to increase or decrease lumbar support. To raise or lower lumbar support, press and hold the top or bottom of ...