Erasing Universal Remote System Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote system device:
1. Press and hold down the two outside buttons until the indicator light begins to flash.
This should take about 10 seconds.
2. Release both buttons.
See also:
Safety Belt Reminder Light
When the engine is started, a chime sounds for several
seconds to remind a driver to fasten the safety belt,
unless the driver safety belt is already buckled.
The safety belt light comes
on a ...
Select Button
(Select): Press the
select button to reset
certain DIC functions, turn off or acknowledge
messages on the DIC display, and set your
customization settings. For example, this button
will allow y ...
Recommended Fuel
Use regular unleaded gasoline with a posted octane rating of 87 or higher. If
the octane rating is less than 87, an audible knocking noise, commonly referred
to as spark knock, might be heard when ...