Starting the Vehicle with a Low Transmitter Battery

If the transmitter battery is weak, the DIC may display NO REMOTE DETECTED when you try to start the vehicle. The REPLACE BATTERY IN REMOTE KEY message may also be displayed at this time.

To start the vehicle:

1. Remove the cupholder liner from the center console cupholder. See Cupholders .

2. Place the transmitter in the transmitter pocket with the buttons facing up.

3. With the vehicle in P (Park) or N (Neutral), press the brake pedal and the ignition control. See Starting the Engine  for additional information about the vehicle's keyless ignition with pushbutton start.

Replace the transmitter battery as soon as possible.

    See also:

    Head Restraint Adjustment
    Do not drive until the head restraints for all occupants are installed and adjusted properly. For more information see Head Restraints. ...

    What to Add
    When you do need brake fluid, use only DOT-3 brake fluid. Use new brake fluid from a sealed container only. Always clean the brake fluid reservoir cap and the area around the cap before removing i ...

    Starting the Vehicle
    1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold until the turn signal lamps flash, or for about two seconds if the v ...