Setting Cruise Control

If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used.

1. Press control system on. The indicator to turn the cruise control system on. The indicator light in the instrument panel cluster comes on.

2. Get to the speed desired.

3. Move the thumbwheel down toward SET/− and release it.

The desired set speed briefly appears in the instrument panel cluster.

4. Take your foot off the accelerator pedal.

    See also:

    Securing an Add-on Child Restraint in the Vehicle
    CAUTION: A child can be seriously injured or killed in a crash if the child restraint is not properly secured in the vehicle. Make sure the child restraint is properly installed in the vehicle ...

    Trunk Deck Inboard Taillamp and Backup Lamp
    Driver Side Shown, Passenger Side Similar A. Backup Lamp B. Taillamp To replace any one of these bulbs: 1. Open the trunk. 2. Remove the push pins (A) retaining the trunk deck trim cover. 3. ...

    Introduction
    Notice: Maintenance intervals, checks, inspections, recommended fluids, and lubricants are necessary to keep this vehicle in good working condition. Damage caused by failure to follow scheduled ...