Sending a Number During a Call

1. Press with “Ready”. The system responds with “Ready” followed by a tone.

2. Say “Dial”. The system responds with “Say a number to send tones” followed by a tone.

3. Say the number to send.

• If the system clearly recognizes the number it responds with “OK, Sending Number” and the dial tones are sent and the call continues.

• If the system is not sure it recognized the number properly, it responds “Dial Number, Please say yes or no?” followed by a tone. If the number is correct, say “Yes”. The system responds with “OK, Sending Number” and the dial tones are sent and the call continues.

    See also:

    Starting the Vehicle with a Low Transmitter Battery
    If the transmitter battery is weak, the DIC may display NO REMOTE DETECTED when you try to start the vehicle. The REPLACE BATTERY IN REMOTE KEY message may also be displayed at this time. To star ...

    Entry Lighting
    The headlamps, parking lamps, taillamps, and most of the interior lamps turn on briefly when is pressed on the Remote Keyless Entry (RKE) transmitter. After about 30 seconds the exterior lamps ...

    Tachometer
    The tachometer displays the engine speed in revolutions per minute (rpm). Notice: If the engine is operated with the tachometer in the shaded warning area, the vehicle could be damaged, and the damag ...