Voice Pass-Thru

Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturers user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone.

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Bluetooth”. The system responds with “Bluetooth ready” followed by a tone.

3. Say “Voice”. The system responds with “OK, accessing <phone name>”.

• The cell phone’s normal prompt messages will go through its cycle according to the phone’s operating instructions.

    See also:

    Cruise Control Messages
    CRUISE SET TO XXX This message displays when the cruise control is set and shows the speed it was set to. See Cruise Control for more information. ...

    Fog Lamps
    Use the fog lamps for better vision in foggy or misty conditions. The ignition must be in RUN for the fog lamps to work. The fog lamp button is located on the instrument panel to the right of ...

    Removing and Replacing the Floor Mats
    Pull up on the rear of the floor mat to unlock each retainer and remove. Reinstall by lining up the floor mat retainer openings over the carpet retainers and snap into position. Make sure the fl ...