Using the Digit Dial Command

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Digit Dial”. The system responds with “Digit dial using <phone name>, please say the first digit to dial” followed by a tone.

3. Say the digit to be dialed one at a time. Following each digit, the system will repeat back the digit it heard followed by a tone.

4. Continue entering digits until the number to be dialed is complete. After the whole number has been entered, say “Dial”. The system responds with “OK, Dialing” and dials the number.

• If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.

• To hear all of the numbers recognized by the system, say “Verify” at any time and the system will repeat them.

    See also:

    Lockout Protection
    This feature stops the power door locks from locking when the key is in the ignition and a door is open to protect you from locking your key in the vehicle. If the power lock switch is pressed w ...

    Capacities and Specifications
    Capacities and Specifications Engine Specifications ...

    Safety Belt Pretensioners
    This vehicle has safety belt pretensioners for front outboard occupants. Although the safety belt pretensioners cannot be seen, they are part of the safety belt assembly. They can help tighten the sa ...