Using the Dial Command

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Dial”. The system responds with “Dial using <phone name>”. “Number please” followed by a tone.

3. Say the entire number without pausing.

• If the system recognizes the number, it responds with “OK, Dialing” and dials the number.

• If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say “Yes”. The system responds with “OK, Dialing” and dials the number.

If the number is not correct, say “No”. The system will ask for the number to be re-entered.

    See also:

    Weatherstrips
    Silicone grease on weatherstrips will make them last longer, seal better, and not stick or squeak. Apply silicone grease with a clean cloth. During very cold, damp weather frequent application may be ...

    Towing with a Stability Control System
    When towing, the sound of the stability control system might be heard. The system is reacting to the vehicle movement caused by the trailer, which mainly occurs during cornering. This is normal wh ...

    Exterior Lamp Controls
    Exterior Lamp Controls The exterior lamp control is located on the instrument panel on the outboard side of the steering wheel. Turn the control to the following positions: (Off): Turns of ...