Using the Delete Command

The delete command allows specific name tags to be deleted.

To use the delete command:

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Delete”. The system responds with “Delete, please say the name tag” followed by a tone.

3. Say the name tag to be deleted. The system responds with “Would you like to delete, <name tag>? Please say yes or no”.

• If the name tag is correct, say “Yes” to delete the name tag. The system responds with “OK, deleting <name tag>, returning to the main menu.” • If the name tag is incorrect, say “No”. The system responds with “No. OK, let’s try again, please say the name tag.”

    See also:

    When to Check and Change AutomaticTransmission Fluid
    A good time to check your automatic transmission fluid level is when the engine oil is changed. Change the fluid and filter at the intervals listed in Additional Required Services on page 482, and ...

    Programming with a Recognized Transmitter (Keyless Access Vehicles Only)
    A new transmitter can be programmed to the vehicle when there is one recognized transmitter. To program, the vehicle must be off and all of the transmitters, both currently recognized and new ...

    Listing Stored Numbers
    The list command will list all the stored numbers and name tags. Using the “List” Command 1. Press . The system responds “Ready,” followed by a tone. 2. Say “Directory.” 3. Say “Ha ...