Rear Seat Pass-Through

Your vehicle has a small door in the rear seat.

This door allows you to access the trunk from inside the vehicle.

The rear seat armrest must be down for the pass-through door to open. To release the pass-through door, move the release lever up. To close the door, raise it and push it until it latches.

    See also:

    Programming Universal HomeRemote — Rolling Code
    Rolling code garage door openers are used for garage doors produced after 1996 and are code protected. Rolling code means the coded signal is changed every time your remote control garage door ope ...

    Instrument Panel Fuse Block
    The instrument panel fuse block is located in the instrument panel, on the driver side of the vehicle. To access the fuses, open the fuse panel door by pulling down at the top. Press in o ...

    Using the Re-dial Command
    1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...