Adjusting the Speakers (Balance/Fade)
AUDIO: To adjust the balance between the right and the left speakers, push and release the AUDIO knob until BAL (balance) displays.
Turn the knob to move the sound toward the right or the left speakers.
To adjust the fade between the front and the rear speakers, push and release the AUDIO knob until FADE displays. Turn the knob to move the sound toward the front or the rear speakers.
To adjust the balance or fade to the middle position while it is displayed, push the AUDIO knob and hold it until the radio produces one beep.
The balance or fade adjusts to the middle position.
To adjust all tone and speaker controls to the middle position, push and hold the AUDIO knob when no tone or speaker control displays.
ALL CENTERED displays, a beep sounds, and the display level adjusts to the middle position.
See also:
Using the Digit Store Command
The digit store command allows a phone number to be
stored by entering the digits individually.
1. Press and hold for two seconds.
The system
responds with “Ready” followed by a tone.
2. ...
Rear Seat Pass-Through
Your vehicle has a small door in the rear seat.
This door allows you to access the trunk from inside
the vehicle.
The rear seat armrest must be down for the
pass-through door to open. To release ...
Programming Universal HomeRemote — Rolling Code
Rolling code garage door openers are used for
garage doors produced after 1996 and are
code protected. Rolling code means the coded
signal is changed every time your remote control
garage door ope ...
