Sunroof
The vehicle may be equipped with a power sliding sunroof. To open or close the sunroof, the ignition must be turned to ON, ACCESSORY, or Retained Accessory Power (RAP) must be active.
Press and release the back of the control in the overhead console to open the sunroof. Press the front of the control to close the sunroof.
Once the sunroof is closed, press the forward side of the control to open the sunroof to the vent position.
The sunroof has a sunshade which can be pulled forward to block sun rays. If it is in the closed position, it will open when the sunroof is opened.
See also:
Flash-to-Pass
To flash the high beams, pull the
turn signal/lane change lever toward
you, and release. ...
Headlamps, Front Turn Signal, andParking Lamps
To replace a bulb, do the following:
1. Open the hood.
2. Remove the grille by grasping and pulling it
forward.
3. Lift the two headlamp retaining clips.
4. Pull the headlamp assembly away from ...
Turn and Lane-Change Signals
Turn and Lane-Change Signals
Move the lever all the way up or
down to signal a turn.
An arrow on the instrument panel
cluster flashes in the direction of the
turn or lane change.
Raise or l ...