Checking Brake Fluid

The brake/clutch fluid can be checked without taking off the cap by looking at the brake/clutch fluid reservoir.

The fluid level should be above MIN. If it is not, have the brake/ clutch hydraulic system checked to see if there is a leak.

After work is done on the brake/ clutch hydraulic system, make sure the level is above MIN but not over the MAX mark.

When the brake/clutch fluid falls to a low level, the brake warning light comes on. See Brake System Warning Light .

    See also:

    Remote Trunk Release
    To open the trunk, press on the Remote Keyless Entry (RKE) transmitter. Emergency Trunk Release Handle Notice: Do not use the emergency trunk release handle as a tie-down or anchor point when secur ...

    Using the Re-dial Command
    1. Press and hold for two seconds. The system responds with “Ready” followed by a tone. 2. After the tone, say “Re-dial”. The system responds with “Re-dial using <phone name>†...

    Finding a Program Type (PTY) Station(RDS and XM™)
    To select and find a desired PTY perform the following: 1. Press the TYPE button to activate program type select mode. TYPE and a PTY displays. 2. Turn the TYPE knob or press and release the TY ...