Programming the Power Windows

If the battery on the vehicle has been recharged, disconnected, or is not working, the windows with the express-up feature will need to be reprogrammed for the feature to work. Before reprogramming, replace or recharge the vehicle's battery.

To program each front window:

1. The ignition is in ACC/ ACCESSORY or ON/RUN, or in RAP.

2. Press and hold the power window switch until the window is fully open.

3. Pull the power window switch up until the window is fully closed.

4. Continue holding the switch up for approximately two seconds after the window is completely closed.

The window is now reprogrammed. Repeat the process for the other windows.

    See also:

    Headlamps, Front Turn Signal and Parking Lamps
    Driver Side Shown, Passenger Side Similar A. Low-Beam Headlamp B. High-Beam Headlamp C. Parking/Turn Signal Lamp ...

    Cargo Tie Downs
    There are cargo tie downs in the rear of your vehicle that allow you to strap cargo in and keep it from moving. ...

    Halogen Bulbs
    WARNING! Halogen bulbs have pressurized gas inside and can burst if you drop or scratch the bulb. You or others could be injured. Be sure to read and follow the instructions on the bulb pac ...