Starting the Vehicle

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing.

3. Immediately after completing Step 2, press and hold the turn signal lamps flash, or for until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Hydraulic Power Steering
    If your vehicle has hydraulic power steering, it may require maintenance. See Power Steering Fluid (2.4L L4 Engine) or Power Steering Fluid (3.6L V6 Engine). If power steering assist is lost ...

    Tire Sealant and Compressor Kit Storage
    The tire sealant and compressor kit is located in the trunk. 1. Open the trunk. See Trunk 2. Lift the cover. 3. Turn the retainer clockwise and remove the tire sealant and compressor kit. To ...

    Sunroof
    The vehicle may be equipped with a power sliding sunroof. To open or close the sunroof, the ignition must be turned to ON, ACCESSORY, or Retained Accessory Power (RAP) must be active. Press and ...