Windshield Wiper Blade Replacement

Windshield wiper blades should be inspected for wear or cracking. See Scheduled Maintenance.

It is a good idea to clean or replace the wiper blade assembly on a regular basis or when worn. For proper windshield wiper blade length and type, see Maintenance Replacement Parts.

To replace the wiper blade assembly:

1. Turn the ignition to ACC/ACCESSORY with the engine off.

2. Pull the windshield wiper assembly away from the windshield.

3. Squeeze the tabs on each side of the wiper blade

3. Squeeze the tabs on each side of the wiper blade assembly and slide the assembly off the end of the wiper arm.

4. Replace the blade assembly with a new one.

4. Replace the blade assembly with a new one.

Allowing the wiper blade arm to touch the windshield when no wiper blade is installed could damage the windshield. Any damage that occurs would not be covered by your warranty. Do not allow the wiper blade arm to touch the windshield.

5. Repeat the steps for the other wiper.

    See also:

    California Fuel
    If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications. See the underhood emission control label. If this fuel ...

    Setting Preset PTYs (RDS Only)
    These pushbuttons have factory PTY presets. Up to 12 PTYs (six FM1 and six FM2), can be programmed on the six numbered pushbuttons, by performing the following steps: 1. Press BAND to select F ...

    Radio Messages
    CAL ERR (Calibration Error): The audio system has been calibrated for your vehicle from the factory. If CAL ERR displays it means that the radio has not been configured properly for your vehicle a ...