Using the Digit Dial Command

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Digit Dial”. The system responds with “Digit dial using <phone name>, please say the first digit to dial” followed by a tone.

3. Say the digit to be dialed one at a time. Following each digit, the system will repeat back the digit it heard followed by a tone.

4. Continue entering digits until the number to be dialed is complete. After the whole number has been entered, say “Dial”. The system responds with “OK, Dialing” and dials the number.

• If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.

• To hear all of the numbers recognized by the system, say “Verify” at any time and the system will repeat them.

    See also:

    XM Radio Messages
    If you have a Radio with CD or Radio with Six-Disc CD, you can receive these radio display messages. If you have a Radio with CD (MP3), you can receive these radio display messages. ...

    Hood
    To open the hood: 1. Pull up on the hood release handle with this symbol on it. It is located inside the vehicle to the left of the steering column. 2. Go to the front of the vehicle and move t ...

    Playing from MEM
    Playing Back a Previously Recorded CD Turn the TUNE knob to select a track if MEM is already playing from the previously recorded disc. 1. Select Recorded Disc List. 2. Select the disc. 3. S ...