Using the Dial Command

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Dial”. The system responds with “Dial using <phone name>”. “Number please” followed by a tone.

3. Say the entire number without pausing.

• If the system recognizes the number, it responds with “OK, Dialing” and dials the number.

• If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say “Yes”. The system responds with “OK, Dialing” and dials the number.

If the number is not correct, say “No”. The system will ask for the number to be re-entered.

    See also:

    Tire Pressure Monitor System
    The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. The TPMS sensors monitor the air pressure in your tires and transmit tire pressure readings to a ...

    Turning the Rear Vision Camera System On or Off
    To turn the RVC system on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. 5. Select Camera. ...

    Check Gas Cap Light
    If your vehicle has this light, it will come on if your gas cap is not securely fastened. ...