Using the Directory Command

The directory command lists all of the name tags stored by the system. To use the directory command:

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Directory”. The system responds with “Directory” and then plays back all of the stored name tags. When the list is complete, the system returns to the main menu.

    See also:

    Reprogramming a Single UniversalHome Remote Button
    To program a device to Universal Home Remote using a Universal Home Remote button previously trained, follow these steps: 1. Press and hold the desired Universal Home Remote button. Do not relea ...

    Exterior
    While the Regal's styling is definitely understated, the sedan has clean lines and a nice stance. The rear-quarter view is one of its best angles, and the car has one of the most stylish trunklids ...

    Sunroof
    For vehicles with a sunroof, the sunroof only operates when the ignition is in ON/RUN or ACC/ ACCESSORY, or in Retained Accessory Power (RAP). See Retained Accessory Power (RAP)  for more i ...