Using the Store Command

The store command allows a phone number to be stored without entering the digits individually.

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Store”. The system responds with “Store, number please” followed by a tone.

3. Say the complete phone number to be stored at once with no pauses.

• If the system recognizes the number it responds with “OK, Storing” and repeats the phone number.

• If the system is unsure it recognizes the phone number, it responds with “Store” and repeats the number followed by “Please say yes or no”. If the number is correct, say “Yes”. If the number is not correct, say “No”. The system will ask for the number to be re-entered.

4. After the system stores the phone number, it responds with “Please say the name tag” followed by a tone.

5. Say a name tag for the phone number. The name tag is recorded and the system responds with “About to store <name tag>. Does that sound OK?”.

• If the name tag does not sound correct, say “No” and repeat Step 5.

• If the name tag sounds correct, say “Yes” and the name tag is stored. After the number is stored the system returns to the main menu.

    See also:

    Driving in Rain and on Wet Roads
    Rain and wet roads can reduce vehicle traction and affect your ability to stop and accelerate. Always drive slower in these types of driving conditions and avoid driving through large puddles an ...

    Driving
    The front-wheel-drive Verano gets a larger four-cylinder than the Cruze. It's normally aspirated, as opposed to the Cruze's available turbocharged four-cylinder, but it makes for smooth starts and ...

    Power Steering Fluid
    When to Check Power Steering Fluid It is not necessary to regularly check power steering fluid unless you suspect there is a leak in the system or you hear an unusual noise. A fluid loss in this ...