Replacing Restraint System Parts After a Crash

WARNING:
A crash can damage the restraint systems in your vehicle. A damaged restraint system may not properly protect the person using it, resulting in serious injury or even death in a crash. To help make sure your restraint systems are working properly after a crash, have them inspected and any necessary replacements made as soon as possible.

If the vehicle has been in a crash, do you need new safety belts or LATCH system (if equipped) parts? After a very minor crash, nothing may be necessary.

But the safety belt assemblies that were used during any crash may have been stressed or damaged. See your dealer/retailer to have the safety belt assemblies inspected or replaced.

If the vehicle has the LATCH system and it was being used during a crash, you may need new LATCH system parts.

New parts and repairs may be necessary even if the safety belt or LATCH system (if equipped), was not being used at the time of the crash.

If an airbag inflates, you will need to replace airbag system parts. See the part on the airbag system earlier in this section.

Have the safety belt pretensioners checked if the vehicle has been in a crash, if the airbag readiness light stays on after the vehicle is started, or while you are driving. See Airbag Readiness Light.

    See also:

    Adding Washer Fluid
    Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview  for reservoir location. Notice When using concentrated washer fluid, ...

    Entering the Personalization Menus
    1. Press CONFIG to access the Configuration Settings menu. 2. Turn the Menu knob to highlight Vehicle Settings. 3. Press SELECT to select the Vehicle Settings menu. The following list of menu ...

    Starting the Vehicle
    1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold until the turn signal lamps flash, or for about two seconds if the vehicl ...